Reset Clock; Hand Alignment Check; Self Initialization; Manual Setting Analog Clock Set Up And Operation - Primex XR Series Installation Manual

Reset Clock

To manually reset the clock after installation, simply remove its power source for at least 10 seconds and reapply its power
source. The clock automatically initiates the Self Initialization procedure.

Hand Alignment Check

If the hand alignment of a clock is in question, complete the below steps.
1. Press and hold the button on the back of the clock for 3 seconds until it beeps.
2. The hands begin to move at an accelerated speed until all three hands align at the 12 o'clock position. The hands
stop in this position to confirm the hands are all properly aligned.
3. The hands remain in this position until the button is again held down for 3 seconds. Press and hold the button for
3 seconds for a second time; the clock enters the Self Initialization procedure. For additional information, see "Self
Initialization" located on page 12.

Self Initialization

When the button on the back of the clock is pushed quickly and released, the clock emits a double-beep and the clock
begins to look for a signal from the transmitter.
If a signal is received, the clock emits a beep once per second, for one minute, every time a valid packet is
l
decoded. The clock hands automatically adjust to the correct time.
If the clock is in a marginal signal area, it emits a beep once every few seconds. Battery operated models will
l
work in marginal signal areas, but may result in reduced battery life.
No beeping indicates a signal is not received from the transmitter.
l
M S
ANUAL
Operation of a battery-operated analog clock for use with Primex Wireless XR Time Synchronization system requires initial
set up to receive its time from the system transmitter.
A manual setting model has both a button and a grey set wheel on the back of the clock.
NOTE: An electric-powered clock does not require a set up procedure to receive its time from the system transmitter.
Primex Wireless
A C
ETTING NALOG LOCK
XR Series Analog Clock Installation Guide
S U O
ET P AND PERATION
12