Electric Analog Clock Installation - Primex XR Series Install Manual

Electric Analog Clock Installation

Installation must adhere to local codes and ordinances.
Pluggable surface receptacle
The power cord is wrapped around the two posts on the back of the clock and can be unwrapped or wrapped to the desired
length.
The power cord is to be routed through the strain relief away from the upper portion of the clock's antenna to maintain optimal
reception and then exit through the slot located at the bottom of the clock. The excess cord can then be wound around the two
cord posts.
NOTE
When hanging the clock on the wall, be sure the power cord does not get pinched between the mounting hardware and
the back of the clock. Be careful not to damage the antenna wires when hanging or removing the clock.
Pluggable recessed receptacle
The receptacle may be behind the clock, with the excess cord wound around the two cord posts.
To ensure that the cord does not prevent the clock from resting flush against the wall, the center of the recessed receptacle
should be located about 2.0 in. (6.35 cm) to the right or left of the center of the clock and 2.75 in. (6.9 cm) down of clock
mounting nail or screw.
Recessed receptacle
25