Set Up Automatic Setting Analog Clock (Battery-Operated) - Primex XR Series Installation Manual

Set up Automatic Setting Analog Clock (Battery-operated)

To set up an Automatic Setting Analog Clock, install the batteries and the clock automatically initializes its set up and
searches for a signal from transmitter to receive its time.
WARNING: Battery-powered models only: For sites with multiple transmitters or repeaters, do not install clock
Once set, clocks should be tested at their final installation location to verify the presence of the transmitter signal in that
area. To confirm that an automatic setting analog clock is placed in a good signal area, carefully remove the clock from
the wall, push and IMMEDIATELY release the button, and hang the clock in place.
The clock will scan all channels looking for a transmitter signal. Once the clock finds a channel with a
l
transmitter signal, a series of beeps will sound from the clock.
The clock will beep each time a valid time signal is received, which should be once per second and will
l
continue for one minute.
If the clock is in a marginal signal area, it will beep once every few seconds. No beeping means no signal is
l
received. An Automatic Setting Clock will work in marginal signal areas but may have a slightly reduced battery
life.
NOTE: When clocks are being installed or the signal tested, it is very important not to hold the button down too long
or the hands will proceed to the 12 o'clock position and remain there indefinitely. To make the hands move
again, wait until they have stopped, then press and hold the button again. The clock will enter its normal
setup procedure and set itself.
Primex Wireless
batteries until the clocks are located at their permanent installation location.
XR Series Analog Clock Installation Guide
9