Table of Contents
Advertisement
Install Classic Series Digital Clock/Timer
Installation Requirements
Refer to the Important Safety Instructions before installing, operating or performing maintenance of clocks.
l
Before installing a clock, verify the system Transmitter is operating properly and sending a signal with adequate building
l
coverage.
Broadcast (Transmit) Schedule Transmitter with Internal Antenna: broadcasts its synchronized time continuously to the system
clocks and devices.
Broadcast (Transmit) Schedule Transmitter with External Antenna: broadcasts its synchronized time to the system clocks and
devices from the 39th to the 6th minute of the next hour and changes to a standby mode during the 7th to the 38th minute of
the hour (standard broadcast schedule). During initial power-up, the Transmitter broadcasts for 8 consecutive hours. After the
8 hour power-up period, the Transmitter reverts to its timed broadcast schedule.
Clocks must be installed at a location within adequate transmission range of the Transmitter.
l
Verify the clock's settings have been configured before the clock is installed.
l
Any damage to the clock due to improper wiring voids the warranty. It is at Primex discretion as to whether damage to the
l
clock was caused by improper wiring.
15
Advertisement
Table of Contents
