Single-Sided Analog Clock Installation - Primex XR Series Installation Manual

Single-sided Analog Clock Installation

Complete the steps below to install a single-sided analog clock.
1. Drill holes for the screw anchors per the clock hole spacing specifications. For additional information, see "Clock-
Lock Hole Spacing Specifications" located on page 16.
2. Apply power to the clock.
3. Use a screwdriver to insert and tighten the screw, leaving the top of the screw head 3/8 in.(0.95 cm) out from the
wall.
4. Hold the clock with the face down and align the Clock-Lock hanger with the bottom screw, as shown in Figure 4.
5. Tilt the clock face to vertical and position the clock with the screw heads in the opening of the Clock-Lock hanger.
6. Slide the clock down over the screw heads to latch it into place.
Figure 4: Clock-Lock Installation Illustration
7. If the Automatic Self Initialization was not completed at the clock mounting location, verify the clock is receiving a
signal from the transmitter. Remove the clock and press and IMMEDIATELY release the button located on the back
of the clock.
The clock scans all channels looking for a transmitter signal.
l
Once the clock finds a channel with a transmitter signal, the clock emits a series of beeps. Each time a valid
l
time signal is received the clock emits a beep, which should be once per second and will continue for one
minute.
If the clock is in a marginal signal area, it emits a beep once every few seconds. Battery operated models will
l
work in marginal signal areas, but may result in reduced battery life.
No beeping indicates a signal is not received.
l
NOTE: When a clock is being installed or its transmission signal is being tested, it is very important not to hold the
button down too long or the hands will proceed to the 12 o'clock position and remain there indefinitely. To
release the hands from an indefinite position, press and release the button again. The clock will automatically
initiate the Self Initialization procedure and set itself.
Primex Wireless
XR Series Analog Clock Installation Guide
20