Swann AMI Codes-II Operator's Manual page 76

Table of Contents

AMI Codes-II

Program Overview

Relay 1&2

5.3.2* & 5.3.3*

Input

5.3.4*

Miscellaneous

Language

5.4*

Set defaults

Load Firmware

Password

5.4.4*

Sample ID

Line Break Detection

Interface

Protocol

5.5*

Device Address

Baud Rate

Parity

Sample Flow

5.3.1.3*

Sample Temp.

5.3.1.4*

Case Temp. high

Case Temp. low

Function

Parameter

Setpoint

Hysteresis

Delay

Active

Signal Outputs

Output/Control

Fault

Delay

5.4.1*

5.4.2*

5.4.3*

Messages

Maintenance

Operation

Installation

5.4.5*

5.4.6*

5.5.1*

5.5.21*

5.5.31*

5.5.41*

Flow Alarm

Alarm High

Alarm Low

Alarm High

Alarm Low

5.3.1.5*

5.3.1.6*

5.3.2.1 & 5.3.3.1*

5.3.2.x & 5.3.3.x*

5.3.4.1*

5.3.4.2*

5.3.4.3*

5.3.4.4*

5.3.4.5*

5.4.4.1*

5.4.4.2*

5.4.4.3*

5.4.4.4*

A-96.250.571 / 050517

5.3.1.3.1*

5.3.1.3.x*

5.3.1.4.1*

5.3.1.4.x*

(only with RS485

interface)

* Menu numbers

Table of Contents

Show Quick Links

Quick Links:
Maintenance Schedule

Hide quick links:

Table of Contents

Need help?

Do you have a question about the AMI Codes-II and is the answer not in the manual?

Questions and answers

Nonhlanhla

March 2, 2025

Using the AMI Codes-II, there is Chlorine in the system, yet the system reads 0.00. Reseted, still no feedback. what could be the problem.

1 comments:

Mr. Anderson

March 2, 2025

If the Swann AMI Codes-II system reads 0.00 for chlorine despite chlorine being present, possible issues could include:

1. Reagent Issues – The required reagents (OXYCON ON-LINE DPD, buffer solutions, etc.) might be depleted, expired, or improperly mixed.
2. Clogged or Dirty Components – The sample inlet, inlet filter, or flow regulating valve might be clogged, preventing proper water flow.
3. Calibration or Sensor Issues – The system may need recalibration, or the sensor might be faulty or improperly installed.
4. Power or Electrical Issues – The instrument may not be receiving proper power, or there could be an electrical fault affecting measurement.
5. Interference from Additives – Certain water additives like corrosion inhibitors or cyanuric acid might interfere with chlorine detection.

Checking reagent levels, cleaning components, recalibrating, and verifying power and water flow can help identify and resolve the issue.

This answer is automatically generated