Table of Contents
Advertisement
AMI Codes-II
Operation
5.3.
Main Menu
Messages
Diagnostics
Maintenance
Operation
Installation
Messages
Pending Errors
Message List
Diagnostics
Identification
Sensors
Sample
I/O State
Interface
Maintenance
Calibration
Process Cal.
Simulation
Set Time 23.09.06 16:30:00
Operation
Sensors
Relay Contacts
Logger
Installation
Sensors
Signal Outputs
Relay Contacts
Miscellaneous
Interface
40
Software Structure
1
Menu Messages 1
1.1
Reveals pending errors as well as an event history
(time and state of events that have occurred at an
earlier point of time).
It contains user relevant data.
Menu Diagnostics 2
2.1
Provides user relevant instrument and sample data.
Menu Maintenance 3
3.1
For instrument calibration, relay and signal output
simulation, and to set the instrument time.
It is used by the service personnel.
Menu Operation 4
4.1
User relevant parameters that might need to be
modified during daily routine. Normally password
protected and used by the process-operator.
Subset of menu 5 - Installation, but process-related.
Menu Installation 5
5.1
For initial instrument set up by SWAN authorized
person, to set all instrument parameters. Can be
protected by means of password.
A-96.250.571 / 050517
- Quick Links:
- Maintenance Schedule
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the AMI Codes-II and is the answer not in the manual?
Questions and answers
Using the AMI Codes-II, there is Chlorine in the system, yet the system reads 0.00. Reseted, still no feedback. what could be the problem.
If the Swann AMI Codes-II system reads 0.00 for chlorine despite chlorine being present, possible issues could include:
1. Reagent Issues – The required reagents (OXYCON ON-LINE DPD, buffer solutions, etc.) might be depleted, expired, or improperly mixed.
2. Clogged or Dirty Components – The sample inlet, inlet filter, or flow regulating valve might be clogged, preventing proper water flow.
3. Calibration or Sensor Issues – The system may need recalibration, or the sensor might be faulty or improperly installed.
4. Power or Electrical Issues – The instrument may not be receiving proper power, or there could be an electrical fault affecting measurement.
5. Interference from Additives – Certain water additives like corrosion inhibitors or cyanuric acid might interfere with chlorine detection.
Checking reagent levels, cleaning components, recalibrating, and verifying power and water flow can help identify and resolve the issue.
This answer is automatically generated
Please share Data Sheet for the Pherispatic Pump