Table of Contents
Advertisement
AMI Codes-II
Troubleshooting
Error
E030
EEprom Frontend
E031
Calibration Recout
E032
Wrong Frontend
E033
Power-on
E034
Power-down
E065
DPD / Buffer
E067
Cleaning Solution
A-96.250.571 / 050517
Description
Corrective action
– call service
– call service
– call service
– none, normal status
– none, normal status
– Operating display, upper status line. The
number next to the triangle, indicates
the remaining reagents in%. Refill
reagents on time. See
Reagents, p. 43
Operating display, upper status line. The
number next to the triangle, indicates the
remaining cleaning solution in%. Refill
cleaning solution on time.
Refill or replace
69
- Quick Links:
- Maintenance Schedule
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the AMI Codes-II and is the answer not in the manual?
Questions and answers
Using the AMI Codes-II, there is Chlorine in the system, yet the system reads 0.00. Reseted, still no feedback. what could be the problem.
If the Swann AMI Codes-II system reads 0.00 for chlorine despite chlorine being present, possible issues could include:
1. Reagent Issues – The required reagents (OXYCON ON-LINE DPD, buffer solutions, etc.) might be depleted, expired, or improperly mixed.
2. Clogged or Dirty Components – The sample inlet, inlet filter, or flow regulating valve might be clogged, preventing proper water flow.
3. Calibration or Sensor Issues – The system may need recalibration, or the sensor might be faulty or improperly installed.
4. Power or Electrical Issues – The instrument may not be receiving proper power, or there could be an electrical fault affecting measurement.
5. Interference from Additives – Certain water additives like corrosion inhibitors or cyanuric acid might interfere with chlorine detection.
Checking reagent levels, cleaning components, recalibrating, and verifying power and water flow can help identify and resolve the issue.
This answer is automatically generated
Please share Data Sheet for the Pherispatic Pump