Samsung OfficeServ 7200 Programming Manual page 354

CHAPTER 2. MMC Programming
No Parameter
14 PROVISIONAL
TIME
15 INV.NO RESP
TIME
16 GEN.NO
RESP TIME
17 REQ.RETRY
TIME
18 SIP SERVER
ENABLE
20 SIP SERVER
IP
28 SIP SERVER
PORT
29 SIGNAL PORT
32 SEND CLIP
TABLE
33 INCOMING
MODE
34 ALLOW GW
CHECK
35 REGIST T-GW
NUM
36 REGIST S-GW
NUM
37 CLIR WITH
NUMBER
38 SIP
REGISTERED
Samsung Business Communications
Description
After receiving the Provision Response, the User Agent
waits for this length of time until Timeout ends. The range
is 0~999900 ms.
Before sending Cancel for the Invite Request, the User
Agent waits for this length of time. The range is
0~99900 ms.
Before sending Cancel for General Request, the User
Agent waits for this length of time. The range is
0~99900 ms.
After sending General Request, the User Agent waits for
the Final Response for this length of time. The range is
0~99900 ms.
Sets ENABLE or DISABLE to use an optional, external
industry-standard SIP Server.
Sets SIP server IP address.
Sets the port to use on the SIP Server.
Indicates the port number for SIP signalling and sets a
range of numbers allowed by firewall equipment. The
common and default IP path or port used is 10000.
Refers to SEND CLI NUMBER (MMC 323), which pro-
vides calling party identification when using the MGI as a
SIP gateway.
This provides station ID of the calling station. A single-
digit value corresponding to the desired table in MMC
323 should be entered here. This is only used when
MMC 405 value is null.
This option selects how incoming calls are routed when
the MGI is used as a SIP gateway.
0 FOLLOW TRUNK RING: Follows MMC 406
1 FOLLOW DID TRANS: Follows MMC 714 (default)
2 FOLLOW INCOM DGT: Follows MMC 724
When using a gatekeeper, this permits the SIP gateway
to check for gatekeeper presence.
System number when registering as a trunking gateway.
System number when registering as a gateway for sta-
tions.
When this option is enabled, the CLIP number is sent to
the network even if the CLIP restriction flag is set.
Display the status of registration to the SIP Server.
OfficServ 7200 Programming Guide
Default
180000 m
5000 ms
5000 ms
5000 ms
DISABLE
0.0.0.0.
5060
10000
1
FOLLOW DID
TRANS
DISABLE
4100
4200
DISABLE
NO
2-323