Samsung OfficeServ 7200 Programming Manual page 340

CHAPTER 2. MMC Programming
[831] MGI PARAMETERS
This MMC provides a mean to configure the Internet Protocol (IP) addressing of the MGI
card(s) in the system.
No Parameter
0 IP ADDRESS
1 GATEWAY
2 SUB MASK
3 IP TYPE
4 PUBLIC IP
5 PUB PORT
6 VERSION
8 CARD RESET
Samsung Business Communications
Specifies the IP address for the MGI card.
Specifies the designated IP gateway address used for contacting
IP devices beyond the local subnet.
Specifies the IP subnet mask. This parameter is used by the system to
calculate the range of IP devices (subnet) that are within 'direct reach'
of the MGI (without having to go through the designated network IP
gateway).
Specifies if the system will be routing data over a public or private
network.
The MGI will originate communications, to IP phones and VoIP
connections outside the local network, using this IP address. If this
IP address sets 0.0.0.0, 255.255.255.255 or default value then this
MGI card uses private IP only. See System IP Type on MMC 830.
Public Port
No entry required. Used to indicate revision of MGI3 S/W.
Reboots MGI card.
MGI PARAMETERS
- IP ADDRESS, GATEWAY, and SUB MASK—any changes to these parameters
will not be applied until the MGI card is reset.
- When changing any IP address/value, three digits must be entered for each (oc-
tet) field. For example, 192.168.1.10 should be entered as 192 168 001 010.
OfficServ 7200 Programming Guide
Description
2-309