Samsung OfficeServ 7200 Programming Manual page 173

CHAPTER 2. MMC Programming
Timer Name
FIRST DIGIT TIME
HOK FLASH MAX TM
HOK FLASH MIN TM
HOOK OFF TIME
HOOK ON TIME
INQUIRY RELEASE
INTER DIGIT TIME
ISDN INT DGT TM
KMMC LOCK OUT TM
LCR ADVANCE TIME
LCR INTER DIGIT
LONG KEY DETECT
LONG KEY REPEAT
MCL DELAY TIME
MS LED ON TIME
Samsung Business Communications
Default Range Unit
10 1-250 SEC
120 20-2500
MSEC
80 20-2500
MSEC
100 20-2500
MSEC
200 20-2500
MSEC
30 1-250 SEC
10 1-250 SEC
7 1-15 SEC
60 10-50 SEC
5 1-250 SEC
5 1-250 SEC
600 0-2500
MSEC
300 0-2500
MSEC
4 0-9 SEC
5 1-10 SEC
OfficServ 7200 Programming Guide
Description
This timer controls how long the system will
wait for dialling to begin before dropping the
dial tone and returning the you to error tone.
This timer monitors the duration of a hook-
switch flash to ensure that the flash is valid
and not a line noise or an accidental hook-
switch bounce LONGEST duration.
This timer monitors the duration of a hook-
switch flash to ensure that the flash is valid
and not a line noise or an accidental hook-
switch bounce SHORTEST duration.
This timer controls the time before dial tone is
sent to a single line station.
This timer sets the minimum amount of time that
the system will recognize as an SLT hang up.
This timer monitors the duration of the interac-
tion of the Soft button to determine when to
return the LCD back to a normal status. This
timer affects only display phones.
This timer controls the grace period between
dialling valid digits before dropping the call
and returning you back to error tone.
This timer controls the grace period between
dialling valid digits and the end of the dialling
string on an ISDN call.
This timer controls the grace period between
programming actions while in a programming
session. The timer automatically returns the sys-
tem to secure programming status.
This timer controls the time before selecting
the next allowable route when a station is
allowed to route advance.
This timer controls the grace period between
dialling valid digits before accessing a trunk.
This timer controls the time a key must be held
down before the key press is repeated.
This timer controls the time between repeated
digits on a long key press.
This timer controls the time when the system
should start transmitting Authorisation Code
after sending MCL access code (Cable &
Wireless 131 access). Available in UK only.
This timer controls the duration a Manual Sig-
nalling key will remain on after use.
2-142