Zero Offset Page In The Control - Siemens SINUMERIK 802D Training Manual

Section 3

3.1 Zero offset page in the control

An offset page is available in the control, where the operator of the ma-
chine can input and check the zero offset values.
Follow:
When working with a milling machine a BCS offset can be used to offset the
surface of the clamping device from the MCS. A WCS offset can then be u-
sed to the origin of the workpiece.
All values can be edited on the offset page.
To simplify the input a pocket calculator is integrated into the control:
By pressing the equals key in the respective
input field, the calculator will start.
SINUMERIK 802D sl Operating and Service Training Manual
Zero offset page in the control
Page 5
Notes
C74
C74