Setting The Zero Offset - Siemens SINUMERIK 840D sl Operating Manual

Function Manual, Basic Functions; Speeds, Setpoint/Actual-Value System, Closed-Loop
Control (G2), Section "Metric/inch dimension system"
Procedure
4.4.3

Setting the zero offset

You can enter a new position value in the actual value display for individual axes when a
settable zero offset is active.
The difference between the position value in the machine coordinate system MCS and the
new position value in the workpiece coordinate system WCS is saved permanently in the
currently active zero offset (e.g. G54).
Universal
Operating Manual, 05/2017, A5E40868517
1. Select the mode <JOG> or <AUTO> in the "Machine" operating area.
2. Press the menu forward key and the "Settings" softkey.
A new vertical softkey bar appears.
3. Press the "Switch to inch" softkey.
A prompt asks you whether you really want to switch over the unit of
measurement.
4. Press the "OK" softkey.
The softkey label changes to "Switch to metric".
The unit of measurement applies to the entire machine.
5. Press the "Switch to metric" softkey to set the unit of measurement of the
machine to metric again.
Setting up the machine
4.4 Settings for the machine
71