Siemens SINUMERIK 802D Training Manual page 58

Section 3
Facing - CYCLE71
Programming
CYCLE71(RTP, RFP, SDIS, DP, DRP, DTB)
Parameters
_RTP
_RFP
_SDIS
_DP
_PA
_PO
_LENG
_WID
_STA
_MID
_MIDA
_FDP
_FALD
_FFP1
_VARI
_FDP1
SINUMERIK 802D sl Operating and Service Training Manual
Milling cycles
retraction plane (absolute)
reference plane (absolute)
safety plane (enter without sign)
final drilling depth (absolute)
starting point of 1st axis (plane you are working in)
starting point of 2nd axis (plane you are working in)
length along 1st axis, incremental with sign from
start point
length along 2nd axis, incremental with sign from
start point
angle between longitudinal axis and the 1st axis of
the plane you are working in (enter without sign)
maximum depth of cut (enter without sign)
maximum width of cut by cutter
distance past end of material in direction of cut
maximum finish depth of cut (enter without sign)
feedrate for surface machining
machining type
UNITS value
1: roughing
2: finishing
TENS value
1: parallel to 1st axis, unidirectional
2: parallel to 2nd axis, unidirectional
3: parallel to 1st axis, changing direction
4: parallel to 2nd axis, changing direction
1 & 2 3 & 4
Distance of overhang by cutter along direction of
cut
Page 6
Notes
C99
C99