Section 2
Locating the PLC Program displays
Notes
2.1 Locating the PLC Program displays
The PLC Program display can be found in the "SYSTEM area". The dis-
plays are only available when the "SERVICE" password is set or higher.
To enter the "SYSTEM" area press the key "SHIFT + ALARM".
In the system area you will see the softkey PLC, upon pressing the softkey
PLC the following picture is displayed:
When entering the PLC area, the default for the control is to open the
"Program list" picture. This function is explained in the hand book module
C33.
The PLC Program displays can be found by pressing the softkey "PLC
Program"
The following picture can be seen:
C28
C28
SINUMERIK 802D sl Operating and Service Training Manual
Page 2