Section 3
Tool types for milling/drilling
Notes
When you have selected this tool type, you must remember to use G17 as
your workplane.
When you set the tool offset you must also remember to set the correct
Axis to Length 1 and Length 2 in the Geometry column.
This is your
This is your
Z axis offset
X axis offset
Shown below is a typical program for drilling on the End Face of your
turned component using G17
Selected
plane
Default plane acti-
vated at end of cycle
C83
C83
SINUMERIK 802D sl Operating and Service Training Manual
Page 8