Siemens SINUMERIK 802D Training Manual page 104

Section 2
This is how the axis are assigned from MILLING to TURNING under
ISO STANDARDS.
Make a note of axis assigned to Length1 & Length2 for Turning.
A turning machine has no Y
axis, the default plane is ZX
(G18). In the case of turning
tools the offset L1 is applied
With G19 on a turning
machine, there is no Y
axis, in the case of a
turning tool L2 is then
assigned to the Z axis.
SINUMERIK 802D sl Operating and Service Training Manual
Working Plane Selection
to X
With G17 on a
turning machine,
there is no Y
axis. Compensa-
tion L3 is there-
Page 4
Notes
C83
C83