New Milling Tool - Siemens SINUMERIK 802D Training Manual

Section 3

3.1 New milling tool

The geometry of the tool has to be entered into the tool offset screen befo-
re it can be used on the machine in a part program.
The following example shows how to perform this task.
After this procedure the tool appears in the tool list.
The length and radius of the tool can now be entered in the left geometry
fields.
Example:
Important:
After each value is input the
SINUMERIK 802D sl Operating and Service Training Manual
New milling tool
input key must be pressed!
Page 4
Notes
C72
C72