Table of Contents
Advertisement
9-36
1977 PONTIAC SERVICE MANUAL
RADl
A SERIES
G A N D AG
SERIES
-w
0
8. Remove mounting brackets, if present, and install
mounts on replacement receiver. Make sure that J nuts are
positioned in place on mounts.
9. Install replacement radio receiver in reverse order of
removal.
Fig. 9-40 Tape Player Convector Wiring
-
A and
G Series
RADIO SUPPRESSION EQUIPMENT
When installing a new radio, or when noise is a problem,
insure that radio suppression equipment is present. See Fig.
9-48 for typical equipment.
ANTENNA LEAD-IN
STEREO LIGHT
All Series
1. Remove radio as outlined above.
2. Remove tape and/or cover from top of radio for access
to dial light.
3. Remove light from socket.
4. To replace, reverse removal procedure.
RADIO DIAL LIGHT
The following radios may have radio dial lights replaced
by pressing the dial plate down to gain access to the bulb; B,
H, H M and X Series radios except integral tape player.
A and G Series with integral tape players allow access
to the dial light bulb through the tape door.
Radio dial lights can be replaced by removing the radio
as previously described on B,
H,
HM and X Series with
integral tape player, on A and G Series without tape player,
and on all F Series.
1. Disconnect lead-in at radio.
2. Connect a length of wire to lead-in connecter to aid
in pulling new lead-in into place.
3. Remove lower windshield trim moldings at rear of
hood.
4. Disconnect windshield rubber connecter from antenna
lead-in connecter at cowl.
5. Remove the two attaching screws from the connecter
for the antenna lead-in to cowl.
6. Pull lead-in out until wire attached in step 2 is
accessible. Disconnect wire from lead-in.
To Replace
1. Wrap pull-in wire around new antenna lead-in and
start feeding lead-in through cowl.
2. Apply silicone base sealer to cowl where lead-in
attached to cowl.
3. Pull lead-in into place and install attaching screws.
4. Connect windshield rubber connecter to antenna lead-
in.
5. Install lower windshield trim molding.
6. Remove pull-in wire from antenna lead-in connecter
and plug lead-in into radio.
Advertisement
Table of Contents
