Table of Contents
Advertisement
Titan Instructions for Use - EN
TEOAE440
Operating from this screen:
-
Top left button on the hand held unit will take you into the Protocol screen from where you can
select a different protocol or go into Titan Setup
-
Top middle button will bring you to the View Client screen from where client data can be viewed
and changed and earlier sessions can be reviewed and/or printed. During testing, this button allows
you to Pause the test (excluding IMP440)
-
Top right button will either start the test or stop the test. Done! will appear in the top green panel
when the test is complete
-
Right and Left buttons on the hand held unit will respectively select the right or left ear for testing.
To reactivate binaural testing, after the right or left ear button is pressed, return to the Protocol
screen and reselect the protocol (ABRIS440 only)
-
If data for one or both ears has been collected, and Done! appears in the top green panel, the Up
and Down buttons allow you to scroll through the collected measurements or tables
-
Shoulder box button allows you to start and stop testing when the probe is in the ear or change
ears when the probe is out of the ear
3.5.4
Done Screen
The Titan will automatically go to the Done! screen when it has finished testing a protocol. From here,
measurements from both ears can be reviewed, printed and/or saved.
The center of the screen is where the test
measurement is displayed.
The display will differ depending on the view
selected in the protocol: Basic view or Advanced
view.
Page 40
Advertisement
Table of Contents
