Table of Contents
Advertisement
Titan Instructions for Use - EN
Page 80
Peak pressure should be selected when wanting to perform a
pressurized OAE test. You must run a tympanogram
measurement in the IMP module first for the selected ear before
testing with Peak pressure is possible.
The hardware indication picture indicates whether the hardware
is connected. Simulation mode is indicated when operating the
software without hardware.
When opening the Suite the system will automatically search for
the hardware. If it does not detect the hardware a dialog box pops
up and asks if you want to continue in simulation mode.
Before testing, the Timer symbol indicates after how much time the
TEOAE test will automatically stop. During testing the timer counts
down to zero. You can disable the countdown by clicking on the
timer during testing. As a result the timer will begin counting up and
indicate how much test time has passed. Then the test will
continue until you manually press stop.
When the measurement is rejecting, the timer will stop counting.
Artifact rejection is dependent upon the Acceptable Noise Level
setting and Level tolerance level set in the protocol.
The protocol listing shows all tests that are part of the selected
protocol. The test that is displayed in the test screen area is
highlighted blue or red, depending on the chosen ear.
A checkmark in the box indicates that the test will run when
START is pressed. During testing the tests which have been
completed will automatically become unchecked. Uncheck the
boxes of tests you do not wish to run under the selected protocol
before pressing START.
A white checkmark indicates that (at least some) data for this test
is stored in the memory.
Pause becomes active after testing has started. It allows for
pausing during a test.
START (and STOP) button are used for starting and stopping the
session.
Advertisement
Table of Contents
