Interacoustics Titan Instructions For Use Manual page 72

Titan Instructions for Use - EN
Save & Exit saves the current session in Noah 4 or OtoAccess™
(or to a commonly used XML file when running in standalone
mode) and exits the Suite.
Toggle Ear changes from right to left ear and vice versa in all
modules. When the transducer setup allows it (with headphones
or inserts) you can also toggle to binaural.
List of Defined Protocols allows for selecting a test protocol for
the current test session (refer to the Additional Information
document for more details about protocols).
List of historical sessions accesses historical sessions for
review or the Current Session.
Go to current session takes you back to the current session.
Probe status is shown by a colored bar with description next to it.
When the probe status is Out of ear it will show the color of the
selected ear (blue for left and red for right). When the probe is
detected to be In ear the color is green. When Blocked, Leaking
or Too Noisy the colored bar is amber. When No probe is
detected the status bar is grey.
See section 3.3 for information about probe statuses.
Report editor button opens a separate window for adding and
saving notes to the current or historic session.
The hardware indication picture indicates whether the hardware
is connected. Simulation mode is indicated when operating the
software without hardware.
When opening the Suite the system will automatically search for
the hardware. If it does not detect the hardware a dialog box
pops up and asks if you want to continue in simulation mode.
Before testing, the Timer symbol indicates after how much time
the ABRIS test will automatically stop. During testing the timer
counts down to zero. You can disable the countdown by clicking
on the timer during testing. As a result the timer will begin
counting up and indicate how much test time has passed. Then
the test will continue until you manually press stop.
Pause becomes active after testing has started. It allows for
pausing during a test.
START (and STOP) button are used for starting and stopping the
session.
Select transducer window appears when more than one
transducer is connected to the PreAmplifier (e.g., Probe and
Insert phones). Select the transducer for use before starting the
test.
Page 68