Interacoustics Titan Instructions For Use Manual page 76

Titan Instructions for Use - EN
Go to current session takes you back to the current
session.
Probe status is shown by a colored bar with description next
to it.
When the probe status is Out of ear it will show the color of
the selected ear (blue for left and red for right). When the
probe is detected to be In ear the color is green. When
Blocked, Leaking or Too Noisy the colored bar is amber.
When No probe is detected the status bar is grey.
See section 3.3 for information about probe statuses.
Summary view toggles between displaying result graph or
result graph with test summary tables.
Monaural/Binaural view toggles between showing the
results of a single ear or both ears.
Report editor button opens a separate window for adding
and saving notes to the current or historic session.
Checking the Acceptable noise level Off box disables the
rejection of any recording even when there is too much noise
in the recording.
The Acceptable noise level slider allows setting the
acceptable noise level limit between -30 and +30 dB SPL
above which recordings are considered to be too noisy. The
VU meter indicates the current noise level and becomes
amber in color when exceeding the set level.
Pressure indicator shows whether the test is running at
ambient or peak middle ear pressure. The Target indicator
shows how far away the pressure is from the target.
Peak pressure should be selected when wanting to perform
a pressurized OAE test. You must run a tympanogram
measurement in the IMP module first for the selected ear
before testing with Peak pressure is possible.
The hardware indication picture indicates whether the
hardware is connected. Simulation mode is indicated when
operating the software without hardware.
When opening the Suite the system will automatically search
for the hardware. If it does not detect the hardware a dialog
box pops up and asks if you want to continue in simulation
mode.
Page 72