Non-Redundant Ac Power Supply Unit (Cabled) - Dell PowerEdge R530 Owner's Manual

NOTE: When installing, hot swapping, or hot-adding a new PSU, wait for 15 seconds for the system to recognize the
PSU and determine its status. The PSU redundancy may not occur until discovery is complete. Wait until the new PSU
is discovered and enabled before you remove the other PSU. The PSU status indicator turns green to signify that the
PSU is functioning properly.
Figure 65. Installing an AC PSU
1 release latch
3 PSU
5 PSU handle
Related link
Safety instructions
Before working inside your system
After working inside your system
Removing an AC power supply unit

Non-redundant AC power supply unit (cabled)

Your system supports a cabled non-redundant 450 W AC power supply unit (PSU).
NOTE: When selecting or upgrading your system configuration, verify the system power consumption with the Dell Energy Smart
Solution Advisor at Dell.com/ESSA to ensure optimum power utilization.
Removing a non redundant AC power supply unit cabled)
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage
due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are
shipped with your product.
1 Follow the safety guidelines listed in the Safety instructions section.
2 Follow the procedure listed in the Before working inside your system section.
3 Remove the cooling shroud.
132 Installing and removing system components
2 PSU cable connector
4 power connector