Removing The Optional Internal Dual Sd Module - Dell PowerEdge R430 Owner's Manual

Figure 60. Installing an internal SD card
1. IDSDM
3. SD card 1
5. SD card slot 2
Related references
Safety instructions on page 71
Related tasks
Before working inside your system
After working inside your system

Removing the optional internal dual SD module

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that are shipped with your product.
1. If installed, remove the SD cards.
Temporarily label each SD card with its corresponding slot number before removal. Reinstall the SD cards into
NOTE:
the corresponding slots.
Steps
1. Locate the internal dual SD module (IDSDM) on the system board. To locate the internal dual SD module connector, see the
System board connectors section.
2. Holding the pull tab, lift the IDSDM out of the system.
on page 72
on page 72
2. SD card 2
4. SD card slot 1
Installing and removing system components 123