Toshiba Satellite A10 Maintenance Manual page 366

4.18 Fluorescent Lamp
11. Stick the protection cover S (A), fixing tape (C), fixing tape for lead wire (D).
0 to 0.5 mm
Satellite A10/TECRA A1/Satellite Pro A10 Maintenance Manual (960-445)
Downloaded from www.Manualslib.com
Fit the cover according to
the outline of the screw.
(D)
Figure 4-176 Replacing 15.0 Inch Sharp fluorescent lamp (SXGA+) (24)
manuals search engine
Stick to the side of the bezel.
Make sure the lead wire is
closely attached to the bezel.
0 to 1 mm
Do not make the tape over the
(C)
top of the module.
The tape MUST NOT appear on the display.
Stick the tape according to the outline of the
module. Make sure the tape does not appear
on the side of the module.
4 Replacement Procedures
Fit the cover according to
the outline of the screw.
(A)
Stick the fixing tape at
the center of the module.
4-159