2 Troubleshooting Procedures
2.9
To determine whether the Touch Pad is faulty or not, perform the following procedures:
Procedure 1
Execute the Touch Pad Test in the Diagnostic Program. Refer to Chapter 3, Tests and
Diagnostics for more information on how to perform the test program.
If any error is detected, perform Procedure 2.
Procedure 2
The touch pad is connected to the system board with a cable respectively. The cable may have
come off the connector or the connector may have come off the system board. Disassemble
the computer and check the cable connections. See Chapter 4 for the disassembly procedure.
If there is still an error, go to Procedure 3.
Procedure 3
The touch pad may be damaged. Disassemble the computer and replace the touch pad with a
new one.
2-50
Downloaded from
www.Manualslib.com
Touch Pad Troubleshooting
Procedure 1: Diagnostic Test Program Execution Check
Procedure 2: Connector and Cable Check
Procedure 3: Replacement Check
Diagnostic Test Program Execution Check
Connector and Cable Check
Touch Pad
Replacement Check
Satellite A10/TECRA A1/Satellite Pro A10 Maintenance Manual (960-445)
manuals search engine
2.9 Touch Pad Troubleshooting
System board
PJ3201