Toshiba Satellite A10 Maintenance Manual page 343

4 Replacement Procedures
Assembling the 15.0 Inch SXGA+ LG.Philips Fluorescent Lamp
To assembling the 15.0 inch SXGA+ LG.Philips fluorescent lamp, follow the steps below
and refer to figures 4-100 to 4-103.
1. Install the cover assembly bottom (L), sheets, light guide, adhesive tape and board
assembly.
Figure 4-140 Replacing 15.0 Inch LG.Philips fluorescent lamp (SXGA+) (5)
4-136
Downloaded from www.Manualslib.com
1) Remove the protect sheet from the cover assembly bottom (L).
2) Secure the cover assembly bottom (L) with the two screws.
NOTE: Maximum value of torque is 2.0kg
3) Install the light guide and sheets. (Secure the reflection sheet with double-
sided tape.)
NOTE: No penetration of foreign object is indispensable not to scratch on the
surface of the sheets and light guide.
4) Stick the adhesive tape to fix the sheets.
5) Install the board assembly. (Secure the gate PCB with double-sided tape.)
NOTE: Be careful not to apply excessive force to the PCB and TCP.
Board assembly
Double-sided tape
Adhesive tape
Adhesive tape
Sheets and light guide
Screw
Satellite A10/TECRA A1/Satelitte Pro A10 Maintenance Manual (960-445)
manuals search engine
•
cm.
Double-sided tape
Double-sided tape
Screw
Cover assembly bottom (L)
4.18 Fluorescent Lamp
Adhesive tape
Double-sided tape
Adhesive tape