Toshiba Satellite A10 Maintenance Manual page 268

Personal computer
Hide thumbs Also See for Satellite A10:
Table of Contents

Advertisement

4 Replacement Procedures
Installing the Wireless LAN Antenna/Display Cover/Speaker
The following describes the procedure for installing the wireless LAN antenna, display cover,
and display cable (See Figure 4-37 to 4-44).
1. Install the hinges to the display assembly and secure them with the following screws.
2. Install the left and right speaker nets and bend the edges (at four points each) using a
3. Install the display cover to the display assembly.
4. Open the display at 45-degree slant and secure the hinges to the display cover with
5. Secure the hinges to the display cover with the following screws. Stick two mask
6. (For wireless LAN models only)
7. (For wireless LAN models only)
8. Pass the LCD cable from the bottom of the display cover toward the back side of the
9. Turn the display assembly face down. Close the display and attach the hinge cover.
4-62
Downloaded from
www.Manualslib.com
• M2.5x6
• M2.5x5
device such as a flatblade driver and secure them.
the following screws.
• M2.5x2.8
seals on each side of the display cover.
• M2.5x2.8
• M2.5x6
Fit the wireless LAN antennas to the grooves at the rear of the display cover with
double-sided adhesive tapes. Set the wireless LAN antenna cables and stick four
acetate tapes on the cables.
Pass the wireless LAN antenna cables through the bottom of the display cover toward
the back side of the display assembly.
display assembly. Then install the LCD cable holder and secure the holder with the
following screw.
• M2.5x4
Then open the display and secure two latches of the hinge cover. Turn the display
assembly face down and secure the hinge cover with the following screw.
• M2.5x4
Satellite A10/TECRA A1/Satellite Pro A10 Maintenance Manual (960-445)
manuals search engine
4.17 Wireless LAN Antenna/Display Cover/Speaker
PSP TIGHT screw
x3 (Left: 2, Right:1)
THIN BIND screw
x1 (Right)
THIN BIND screw
x2
THIN BIND screw
x4 (Display cover side)
THIN BIND screw
x2 (FL inverter side)
PSP TIGHT screw
x1
PSP TIGHT screw
x1

Advertisement

Table of Contents
loading

This manual is also suitable for:

Tecra a1Satellite pro a10

Table of Contents