4 Replacement Procedures
Installing the Display Assembly
The following describes the procedure for installing the display assembly (See Figure 4-24 to
4-26).
1. Close the display and install the display assembly on the base assembly from the rear
2. (For wireless LAN models only)
3. Secure the following screws to fix the bottom and rear of the computer.
4. Turn the computer face up and open the display.
5. Turn up the insulator covering the speaker connectors and connect the speaker cables
6. Connect the LCD cable to PJ5600 on the system board.
4-38
Downloaded from
www.Manualslib.com
of the computer.
Pass the wireless LAN cables through the slot and hook the cables on the guides.
• M2.5x5
• M2.5x16
(Blue, Red) to PJ6000 and PJ6001 on the system board respectively. Insert the
insulator inside the chassis.
Satellite A10/TECRA A1/Satellite Pro A10 Maintenance Manual (960-445)
manuals search engine
THIN BIND screw
THIN BIND screw
4.10 Display Assembly
x7
x13