Toshiba Satellite A10 Maintenance Manual page 257

4.16 LCD Unit/FL Inverter
3. Peel off the mask tapes from the sides of the display and remove the following screws
4. With the bottom edge of the LCD unit resting on the display cover, lift the top edge of
5. Remove the following screw fixing the FL inverter.
6. Remove the insulator and disconnect the two cables from the connectors CN1 and
7. Remove the LCD unit from the display cover.
CN2
Insulator
M2x4 SUPER THIN BIND
Satellite A10/TECRA A1/Satellite Pro A10 Maintenance Manual (960-445)
Downloaded from www.Manualslib.com
fixing the LCD unit.
• M2x4 SUPER THIN BIND screw x4
the LCD unit. Peel off the glass tape and disconnect the LCD cable from the
connector on the back of the LCD.
•
M2x4
CN2 on the FL inverter and remove the FL inverter.
M2x4 SUPER THIN BIND
Mask Seal
Figure 4-35 Removing FL Inverter and LCD Unit
manuals search engine
SUPER THIN BIND screw x1
FL Inverter
Mask Seal
CN1
Mask Seal
4 Replacement Procedures
Glass Tape
LCD Cable
Mask Seal
M2x4 SUPER THIN BIND
4-51