4 Replacement Procedures
Setting the bezel
1. Start installing the bezel in the upward direction until it stops at the top left corner.
NOTE: The GND-CU and lamp reflector on the left-hand side must not go beyond the
edges of the bezel.
Be careful not to damage the cables and TAB.
The bezel latches must be engaged (there are five latches on the top edge, and two latches
on the bottom edge).
Next, fit the bezel's edge close to the TAB.
Close the five latches.
4-74
Downloaded from
www.Manualslib.com
次にたTAB側をはめる.
ラッチ5か所をはめる.
2
The fold of GND-CU m ust not
GND-CU折り曲げ有り.
go beyond the bezel's edge.
ベゼルの外に出ないこと.
The fold of reflector m ust not g o
リフレクタ折り曲げ有り.
ベゼルの外に出ないこと
beyond the bezel's edge.
Figure 4-54 Replacing 14 Inch TMD fluorescent lamp (10)
Satellite A10/TECRA A1/Satellite Pro A10 Maintenance Manual (960-445)
manuals search engine
2
2
2
2
4.18 Fluorescent Lamp
1
First, fit the bezel's edge close to the lam p.
ベゼルをランプ側からはめる.
ケーブルをキズつけないように注意
Use care not to dam age the cable.
ラッチ2箇所有り.
Tw o latches