Toshiba Satellite A10 Maintenance Manual page 278

4 Replacement Procedures
Assembling PCB-assembly cell
1. Remove the paper (coated with a mold release) from the double-sided tape in the
2. Turn the backlight on.
3. Check that the backlight is free of dust, foreign objects, or damage. Perform this
CAUTION: Align the top left corner of the cell with the corresponding corner of the
backlight unit, as indicated by
Be careful not to damage the TAB.
4-72
Downloaded from www.Manualslib.com
three areas on the replacement backlight unit. The areas are at the top and on both
sides. See Figure 4-52.
check also for the reverse side of the cell. Then install the cell of the PCB assembly in
the backlight unit.
2
左上突き当て
Align the top left
corner.
Figure 4- 52 Replacing 14 Inch TMD fluorescent lamp (8)
Satellite A10/TECRA A1/Satellite Pro A10 Maintenance Manual (960-445)
manuals search engine
in Figure 4-52.
ＰＣＢ付きセル
Cell of PCB
バックライト
Backlight
1
両面テープ剥離紙とる：３箇所
Remove the paper on the double-side tape (three locations).
4.18 Fluorescent Lamp