Mounting the Slide Rails on the Sides of the Switch
Use these steps to install the slide rails on the sides of the switch as shown in
Figure
kit) and left and right slide rails to complete this procedure.
Note:
make the device lighter and easier to handle.
1. On the Edge Switch 2/24, remove the six screws (three screws per side) that
Note:
2. Using the torque driver and the screws you removed earlier, attach the left and
Edge Switch 2/24 Installation Guide
6. You will need a torque driver with a T10 Torx bit (not supplied in the
You may want to remove the Edge Switch 2/24 power supplies, as this will
WARNING:
Before removing the power supplies, review the
StorageWorks Edge Switch 2/24 Service Guide
power supplies.
help hold the switch cover in place.
Do not discard these screws, as you will use them to attach the slide rails.
right slide rails to the Edge Switch 2/24.
Rack Mount Instructions
HP
for details on removing
43