Character Activation Timeout; Character Deactivation; Deactivation Character - Honeywell Xenon 1900 User Manual

Character Activation Timeout

You can set a timeout for the length of time the illumination remains on and
attempting to decode bar codes when using Character Activation Mode. Set the
length (in milliseconds) for a timeout by scanning the following bar code, then set-
ting the timeout (from 1-300,000 milliseconds) by scanning digits from the
Programming Chart,

Character Deactivation

If you have sent a character from the host to trigger the scanner to begin scanning,
you can also send a deactivation character to stop scanning. Scan the following On
bar code to use character deactivation, then use Deactivation Character (follow-
ing) to select the character you will send from the host to terminate scanning.
Default = Off.

Deactivation Character

This sets the character used to terminate scanning when using Character Deacti-
vation Mode. On the
hex value that represents the character you want to use to terminate scanning.
Scan the following bar code, then use the
341 to read the alphanumeric combination that represents that ASCII character.
Scan Save to finish. Default = 14 [DC4].
Xenon/Granit User Guide
beginning on page 341, then Save. Default = 30,000 ms.
* Off
ASCII Conversion Chart (Code Page
Character Activation Timeout
Programming Chart,
Deactivation Character
On
1252), page 330, find the
beginning on page
129