All Symbologies; Message Length Description - Honeywell Xenon 1900 User Manual

All Symbologies

If you want to decode all the symbologies allowable for your scanner, scan the All
Symbologies On code. If on the other hand, you want to decode only a particular
symbology, scan All Symbologies Off followed by the On symbol for that particular
symbology.
Note: Scanner performance may reduce by scanning All Symbologies On. Only scan All
Symbologies On when needed.
Note: When All Symbologies On is scanned, 2D Postal Codes are not enabled. 2D Postal
Codes must be enabled separately.

Message Length Description

You are able to set the valid reading length of some of the bar code symbologies.
You may wish to set the same value for minimum and maximum length to force the
scanner to read fixed length bar code data. This helps reduce the chances of a mis-
read.
Example: Decode only those bar codes with a count of 9-20 characters.
Min. length = 09
Max. length = 20
Example: Decode only those bar codes with a count of 15 characters.
Min. length = 15
Max. length = 15
For a value other than the minimum and maximum message length defaults, scan
the bar codes included in the explanation of the symbology, then scan the digit
value of the message length and Save bar codes from the
beginning on page 341. The minimum and maximum lengths and the defaults are
included with the respective symbologies.
178
All Symbologies On
All Symbologies Off
Programming Chart,
Xenon/Granit User Guide