Troubleshooting A Cordless Scanner - Honeywell Xenon 1900 User Manual

Troubleshooting a Cordless Scanner

Note: Make sure that your scanner's battery is charged.
Visit the Services and Support section of our website (www.honeywellaidc.com) to
check for the latest software for both the scanner and the base or Access Point.
Is the scanner having trouble reading your symbols?
If the scanner isn't reading symbols well, check that the symbols:
•
•
•
Is the bar code displayed but not entered into the application?
The bar code is displayed on the host device correctly, but you still have to press a
key to enter it (the Enter/Return key or the Tab key, for example).
•
The scanner won't read your bar code at all.
•
•
•
Xenon/Granit User Guide
Aren't smeared, rough, scratched, or exhibiting voids.
Aren't coated with frost or water droplets on the surface.
Are enabled in the base or Access Point to which the scanner connects.
You need to program a suffix. Programming a suffix enables the scanner to
output the bar code data plus the key you need (such as "CR") to enter the data
into your application. Refer to
information.
Scan the sample bar codes in the back of this manual. If the scanner reads the
sample bar codes, check that your bar code is readable.
Verify that your bar code symbology is enabled (see
If the scanner still can't read the sample bar codes, scan
page 178.
Prefix/Suffix Overview on page 151 for further
Chapter 9).
All Symbologies on
325