User-Specified Reread Delay
If you want to set your own length for the reread delay, scan the bar code below,
then set the delay (from 0-30,000 milliseconds) by scanning digits from the
Programming Chart,
2D Reread Delay
Sometimes 2D bar codes can take longer to read than other bar codes. If you wish
to set a separate Reread Delay for 2D bar codes, scan one of the programming
codes that follows. 2D Reread Delay Off indicates that the time set for
Delay
Character Activation
You may use a character sent from the host to trigger the scanner to begin scan-
ning. When the activation character is received, the scanner continues scanning
until either the
acter is received (see
Xenon/Granit User Guide
beginning on page 341, then Save.
is used for both 1D and 2D bar codes. Default = 2D Reread Delay Off.
* 2D Reread Delay Off
Medium (2000ms)
Extra Long (4000ms)
Character Activation Timeout
Deactivation Character
User-Specified Reread Delay
(page 5-129), the deactivation char-
on page 129), or a bar code is trans-
Reread
Short (1000ms)
Long (3000ms)
127