Changing A Granit Scanner Battery; Troubleshooting A Corded Scanner - Honeywell Xenon 1900 User Manual

Changing a Granit Scanner Battery

1. Twist the tab in the bottom of the end cap and open the hinged battery door.
2. Remove the battery from the handle.
3. Insert replacement battery.
4. Close the battery door and twist the tab to lock it.
Note: The battery door is designed to pop off the hinge if the scanner is dropped while
changing a battery. If this occurs, simply snap it back on.

Troubleshooting a Corded Scanner

The scanner automatically performs self-tests whenever you turn it on. If your
scanner is not functioning properly, review the following Troubleshooting Guide to
try to isolate the problem.
Is the power on? Is the aimer on?
If the aimer isn't illuminated, check that:
•
•
•
Is the scanner having trouble reading your symbols?
If the scanner isn't reading symbols well, check that the symbols:
•
•
•
Is the bar code displayed but not entered?
Xenon/Granit User Guide
(When new, the battery door may stick. Use pliers to twist the tab and open the
door until it loosens up.)
The cable is connected properly.
The host system power is on (if external power isn't used).
The trigger works.
Aren't smeared, rough, scratched, or exhibiting voids.
Aren't coated with frost or water droplets on the surface.
Are enabled in the scanner or in the decoder to which the scanner connects.
323