Preferred Symbology Default; Output Sequence Overview; Output Sequence Editor; To Add An Output Sequence - Honeywell Xenon 1900 User Manual

Preferred Symbology Default

Scan the bar code below to set all Preferred Symbology entries to their default val-
ues.

Output Sequence Overview

Output Sequence Editor

This programming selection allows you to program the scanner to output data
(when scanning more than one symbol) in whatever order your application
requires, regardless of the order in which the bar codes are scanned. Reading the
Default Sequence symbol programs the scanner to the Universal values, shown
below. These are the defaults. Be certain you want to delete or clear all formats
before you read the Default Sequence symbol.
Note: To make Output Sequence Editor selections, you'll need to know the code I.D., code
length, and character match(es) your application requires. Use the Alphanumeric
symbols from the
trigger while reading each bar code in the sequence.

To Add an Output Sequence

1. Scan the Enter Sequence symbol (see
2. Code I.D.
3. Length
4. Character Match Sequences
136
Programming Chart,
On the Symbology Charts
to apply the output sequence format. Locate the Hex value for that symbology
and scan the 2 digit hex value from the Programming Chart (inside back cover).
Specify what length (up to 9999 characters) of data output will be acceptable
for this symbology. Scan the four digit data length
beginning on page 341. (Note: 50 characters is entered as 0050. 9999 is a
universal number, indicating all lengths.) When calculating the length, you
must count any programmed prefixes, suffixes, or formatted characters as part
of the length (unless using 9999).
On the ASCII Conversion Chart (Code Page
that represents the character(s) you want to match. Use the
Chart, beginning on page 341, to read the alphanumeric combination that
represents the ASCII characters. (99 is the Universal number, indicating all
characters.)
Preferred Symbology Default
beginning on page 341. You must hold the
Require Output
on page 327, find the symbology to which you want
1252), page 330, find the Hex value
Sequence, page 139).
Programming Chart,
Programming
Xenon/Granit User Guide