Search Commands - Honeywell Xenon 1900 User Manual

Move the cursor to the end
EA Move the cursor to the last character in the input message. Syntax = EA.

Search Commands

Search forward for a character
F8 Search the input message forward for "xx" character from the current cursor
position, leaving the cursor pointing to the "xx" character. Syntax = F8xx where xx
stands for the search character's hex value for its ASCII code.
Refer to the
decimal, hex and character codes.
F8 Example: Send bar code data that starts after a particular character
Search for the letter "D" in bar codes and send all the data that follows, including
the "D." Using the bar code above:
Command string: F844F10D
F8 is the "Search forward for a character" command
44 is the hex value for "D"
F1 is the "Send all characters" command
0D is the hex value for a CR
The data is output as:
DEFGHIJ
<CR>
Search backward for a character
F9 Search the input message backward for "xx" character from the current cursor
position, leaving the cursor pointing to the "xx" character. Syntax = F9xx where xx
stands for the search character's hex value for its ASCII code.
Refer to the
decimal, hex and character codes.
Xenon/Granit User Guide
ASCII Conversion Chart (Code Page 1252),
ASCII Conversion Chart (Code Page 1252),
beginning on page 330 for
beginning on page 330 for
167