Hands Free Time-Out; Reread Delay - Honeywell Xenon 1900 User Manual

Hands Free Time-Out

The Scan Stand and Presentation Modes are referred to as "hands free" modes. If
the scanner's trigger is pulled when using a hands free mode, the scanner changes
to manual trigger mode. You can set the time the scanner should remain in manual
trigger mode by setting the Hands Free Time-Out. Once the time-out value is
reached, (if there have been no further trigger pulls) the scanner reverts to the
original hands free mode.
Scan the Hands Free Time-Out bar code, then scan the time-out duration (from 0-
300,000 milliseconds) from the
Save. Default = 5,000 ms.

Reread Delay

This sets the time period before the scanner can read the same bar code a second
time. Setting a reread delay protects against accidental rereads of the same bar
code. Longer delays are effective in minimizing accidental rereads. Use shorter
delays in applications where repetitive bar code scanning is required. Reread Delay
only works when in a
126
Presentation Mode
Short (500 ms)
Long (1000 ms)
Programming Chart,
Hands Free Time-Out
(see page 120). Default = Medium.
beginning on page 341, then
* Medium (750 ms)
Extra Long (2000 ms)
Xenon/Granit User Guide