Honeywell Xenon 1900 User Manual page 255

B - Beeper
Causes a beep to sound after an image is snapped.
T - Wait for Trigger
Waits for a hardware trigger press before taking the image. This is only available
when using Photo Style (1P).
L - LED State
Determines if the LEDs should be on or off, and when. Ambient illumination (0L) is
preferred for taking pictures of color documents, such as ID cards, especially when
the scanner is in a stand. LED illumination (1L) is preferred when the scanner is
handheld. LED State is not available when using Decoding Style (0P).
E - Exposure
Exposure is used in Manual Style only (2P), and allows you to set the exposure
time. This is similar to setting a shutter speed on a camera. The exposure time
determines how long the scanner takes to record an image. On a bright day, expo-
sure times can be very short because plenty of light is available to help record an
image. At nighttime, exposure time can increase dramatically due to the near
absence of light. Units are 127 microseconds. (Default = 7874)
Example:
Xenon/Granit User Guide
0B No beep (default)
1B Sounds a beep when the image is captured.
0T Takes image immediately (default)
1T Waits for a trigger press, then takes the image
0L LEDs off (default)
1L LEDs on
nE Range: 1 - 7874
Exposure at 7874E with
fluorescent lighting:
Exposure at 100E with
fluorescent lighting:
235