Batch Mode Beep; Batch Mode Storage - Honeywell Xenon 1900 User Manual

the scanner's buffer space is full, any bar codes scanned generate an error tone. In
order to scan bar codes again, the data must be transmitted to the base or Access
Point. Once the data is transmitted, it is cleared in the scanner.
Persistent Batch Mode is the same as Inventory Batch Mode, except that once the
data is transmitted to the base or Access Point, it is retained in the scanner. If you
want to transmit more than once, you can do so using this mode. In order to clear
the scanner's buffer, you must scan
Default = Batch Mode Off.

Batch Mode Beep

When scanning in
bar code is scanned. If using a Granit scanner, it also vibrates. When Batch Mode
Beep is On, you will also hear a click when each bar code is sent to the host. If you
do not want to hear these clicks, scan Batch Mode Beep Off. Default = Batch Mode
Beep On.

Batch Mode Storage

When a scanner is storing data during a Batch Mode process, you can select
whether the data is stored in Flash memory or in RAM.
60
* Batch Mode Off
Inventory Batch Mode
Inventory Batch Mode
Batch Mode Beep Off
Clear All Codes (see page
(page 60), the scanner beeps every time a
Xenon/Granit User Guide
64).
Automatic Batch Mode
Persistent Batch Mode
* Batch Mode Beep On