End Character Activation After Good Read
After a bar code is successfully detected and read from the scanner, the aimer can
be programmed either to remain on and scanning, or to turn off. When End Char-
acter Activation After Good Read is enabled, the aimer turns off and stops scan-
ning after a good read. If you scan Do Not End Character Activation After Good
Read, the aimer remains on after a good read. Default = End Character Activation
After Good Read.
Activation After Good Read
Character Activation Timeout
You can set a timeout for the length of time the aimer remains on and attempting
to decode bar codes when using
liseconds) for a timeout by scanning the following bar code, then setting the time-
out (from 1-65535 milliseconds) by scanning digits from the
then scanning Save. Default = 5000 ms.
Character Deactivation Mode
If you have sent a character from the host to trigger the scanner to begin scanning,
you can also send a deactivation character to stop scanning. Scan the following On
bar code to use character deactivation, then use
the character you will send from the host to terminate scanning. Default = Off.
86
Do Not End Character
* Off
Character Activation
Character Activation Timeout
Deactivation Character
Voyager 1470/1472 User Guide
* End Character Activation
After Good Read
Mode. Set the length (in mil-
Programming
to select
On
Chart,