NEC 28i System Manual page 90

1202 - DCI Port Type
Telephone Programming Instructions
To enter data for Program 1202 (DCI Port Type):
1. Enter the programming mode.
2. 1202 + HOLD.
DCI No?
3. Enter the DCI software port you want to program + HOLD.
DCI Module software ports are 1-144. 3-DCI software ports
are 145-288.
DCI Type:
4. Enter the DCI type for the software port selected in the previous
step + HOLD
0 = None, 1 = DCI connected to RS-232 DTE port, 2 = DCI
connected to Centronics port, 3 = Not used, 4 = DCI connected
to RS-232 DCE port.
DCI Sub Type:
5. Enter the DCI's subtype (1-10) + HOLD
DCI No?
6. Repeat from step 3 to program another DCI software port.
OR
HOLD to exit.
3-32