Before Programming; Before You Start Programming; How To Use This Section - NEC 28i System Manual

Before You Start Programming

This section provides you with the detailed information about the
system's Hotel/ Motel programs. By changing a program, you
change the way the Hotel/Motel feature associated with that program
works. In this section, you'll find out about each program, the fea-
tures that the program affects and how to enter the program data into
system memory.
Do not start customizing your Hotel/Motel features without
first reading Section 2, Hotel/Motel Features.
When you want to customize a Hotel/Motel feature, find it in Section
2 and learn about it. Section 2 will tell you what programs you have
to change to get the operation you want. Look the program up in this
section if you have any questions about how to enter the data.

How to Use This Section

This section lists all the Hotel/Motel programs in numerical order.
For example, Program 0309 is at the beginning of the section and
Program 1101 is at the end. The information on each program is sub-
divided into the following headings.
Description tells what the program is. Along with the Description
are the Conditions and Default Setting. Conditions describe any
limits or special considerations that may apply to the program.
Default Setting lists the default (factory-installed) program data.
When you first install the system, it uses the Default Setting for
all programs.
Note: All programs in this section use the IN level password
(12345678).
Feature Cross Reference provides you with a list of all the fea-
tures affected by the program. You'll want to keep the referenced
features in mind when you change a program. Customizing a fea-
ture may have an effect on another feature that you didn't intend.
Telephone Programming Instructions shows you how to enter
the program's data into system memory. For example:
1. Enter the programming mode.
2. 0309 + HOLD
Mode:1-
tells you to enter the programming mode, dial 0309 from the tele-
phone dial pad and then press the HOLD key. After you do,
you'll then see the message "Mode:1-" on the telephone display.
To learn how to enter the programming mode, see How to Enter
the Programming Mode on the following page.

Before Programming

3-3