Install Chassis In Rack; Add Screws To Rack Post - Magma EB4-1U User Manual

M A G M A

Install Chassis in Rack

Locate a vacant 1U slot in your rack that is within the reach of the one-
meter cable that came with your EB4-1U Expansion System. Install the
rails in the rack as shown below:
Measure the rack from front to
back so you can confirm how
long the rail must be to fit
properly.
Next, assemble
piece with the end bracket as shown and secure with 2 Panhead screws
and locking nut. Ensure the Phillips screw head is located on the "open"
side of the Slide pieces as shown.
Tighten finger tight only to allow for minor
adjustment during assembly.
Depending on the depth of your rack you
may select either the long or the short end
bracket.

Add Screws to Rack Post

Attach 2 Panhead screws into the rack post where you want the chassis
mounted. Be sure you have measured accurately to ensure that
everything fits in the rack correctly. Leave the screws untightened until
after you place the slide rail's fingers between the screws as shown.
If your rack has holes too large for the screws, you
can use the Bar Nut to secure your mounting by
inserting the Panhead screw through the rack hole
and screwing it into the Bar Nut on the reverse
side of the rack post, as shown.
NOTE
Notice that the holes on the Bar Nut are spaced unevenly to
accommodate different racks.
6 Chapter 2
the Slide
Hardware Installation