Pre-Installation Information; Tools Required For Installation; Chapter 2 Hardware Installation - Magma ROBEN Series User Manual

Pre-Installation Information

Before using the Magma Expansion chassis you should perform the following steps:
Inventory the shipping carton contents for all of the required parts
•
Gather all of the necessary tools required for installation
•
Read this manual
•

Tools Required for Installation

To complete the installation of the Magma product you will need a Phillips-head screwdriver and ESD wrist strap to
prevent electrostatic discharge.
Chapter 2 Hardware Installation
The following steps will guide you through the installation of your Magma Expansion System.
CAUTION
Hardware installation shall be performed only by qualified service personnel.
Electrostatic Discharge (ESD) Warning
All add-in cards are susceptible to electrostatic discharge. When moving cards, it is best to carry the
cards in anti-static packaging. If you need to set a circuit card down, be sure to place it inside or on
top of an anti-static surface. For more information, see "Protecting Against Electrostatic Discharge"
in the Preface.
WARNING
High voltages are present inside the expansion chassis when the unit's power cord is plugged into
an electrical outlet. Disconnect the power cord from the AC outlet before removing the enclosure
cover. Turning the system power off at the power on/off switch does not remove power to
components. High voltage is still present.
CAUTION
Before touching anything inside the enclosure, move to an ESD station and follow proper ESD
procedures. Failure to do so may result in electrostatic discharge, damaging the computer or its
components. For more information, see "Protecting Against Electrostatic Discharge" in the Preface.
Roben 3 | Chapter 2 Hardware Installation
Magma
11