Table of Contents
Advertisement
5.5.10
Pulse Generator Inverter
Clear Source Signal can have polarity inverted.
5.5.11
Pulse Generator setting parameters
Table - 11
Pulse Generator setting parameters
Display Name
Clock Pre-scaler
Pulse Generator Clock (MHz)
Pulse Generator Selector
- Pulse Generator Length
- Pulse Generator Length (ms)
- Pulse Generator Frequency (Hz)
- Pulse Generator Start Point
- Pulse Generator Start Point (ms)
- Pulse Generator End Point
- Pulse Generator End Point (ms)
- Pulse Generator pulse-width (ms)
- Pulse Generator Repeat Count
- Pulse Generator Clear Activation
Clear Mode for the Pulse Generators
- Pulse Generator Clear Sync Mode
- Pulse Generator Clear Source
- Pulse Generator Inverter(Polarity)
Pulse Generator Clear Inverter
Note: 1. If Pulse Generator Repeat Count is set to "0", the pulse generator works in free-running mode.
2. The output of the same pulse generator cannot be connected to Clear input.
SP-20000M-CXP2 / SP-20000C-CXP-2
Value
1 to 4096
[Pixel Clock: 40 MHz ]÷[Clock Pre-scaler]
- Pulse Generator 0
- Pulse Generator 1
- Pulse Generator 2
- Pulse Generator 3
1 to 1048575
（[Clock Source]÷[Clock Pre-scaler]）
［ Pulse Generator Length (ms)］
0 to 1048574
（[Clock Source]÷[Clock Pre-scaler]）
1 to 1048575
（[Clock Source]÷[Clock Pre-scaler]）
[ Pulse Generator End Point (ms)]－[ Pulse Generator Start Point (ms)]
0 to 255
- Off
- High Level
- Low level
- Rising Edge
- Falling Edge
- Async mode
- Sync mode
- Low
- High
- Acquisition Trigger Wait
- Acquisition Active
- Frame Trigger Wait
- Frame Active
- Exposure Active
- FVAL
- LVAL
- PulseGenerator0
- PulseGenerator1
- PulseGenerator2
- PulseGenerator3
- Line 7 – CXP IN (Trigger Packet)
- Line 4 – TTL IN 1
- Line 5 – OPTO IN 1
- Nand0 Out
- Nand1 Out
- User Output 0
- User Output 1
- User Output 2
- User Output 3
- Line 10 - TTL 2 In
- Line 11 - LVDS 1 In
- False
- True
-1
-1
-1
-1
- 23 -
x [Pulse Generator Length]
x [Pulse Generator Start Point]
x [Pulse Generator End Point]
Advertisement
Table of Contents
